As a couple who I consulted with at the store said, "Is that your old faucet (Delta faucet in my hand from probably 20 years ago)?"My response, "Yes" .....just to make sure I got the right one.The guy my age responded, "Well, anything is going to be better than that." I laughed, very true.Positives:Very stylishI like the single handle, left/right up for on, very easy and the same as my old Delta.Its high enough to get more space and have dirty dishes in single tub sink, and still be able to fill up a spaghetti pot with hot water.People mentioned, splashing. Mine doesn't splash, but I would say it sits a bit forward (not centered over the garbage disposal/ drain hole), and that may be why its splashing since it's hitting the sink basin, versus going straight into the sink/drain hole.If you have a smaller sink, it may sit too far forward for you, but I didn't find it a problem.Very easy to install. What does that mean? For a three hole sink, you put plumbers putty around the base, and set the base down, without faucet, down and align it with the holes. Second, you just slide/thread the hoses and faucet down the center hole. It comes with braided stainless flexible lines (the best lines you can buy, because they are flexible so you don't need to measure and cut solid copper piping to fit, they are not plastic, so not susceptible to cracking or breaking over time--and flexible, so you don't have to measure length, just hook it up to hot and cold lines -- and the lines are labeled hot/cold). You then thread the nut on the bottom of the faucet, tighten with two screw that go through the nut (easier to see than explain). Hook-up the lines, thats it.For those wondering about the pull out sprayhead, there is no mechanical mechanism to break. Basically, there is just a doughnut metal weight that goes around the hose under the sink, so the weight pulls the spray-head back into the nozzle by virtue of the gravity of the weighted doughut. Very simple, very smooth, nothing to break. Once I saw that, I felt much better. Simple is the best.Putting it in is about a 20 minute to 30 minute job. If I had to do it again, I could probably install it in 10 minutes or less.CONS:I hope this thing doesn't leak. when you turn it off, it drips 5-6 drops, but then doesn't drip any more. I'm hoping that it is just residual water in the head. I do remember some commercials, saying no drip-but those might have been bathroom faucets. Anyway, after turning it off, you get a few drips--just a heads-up.Nothing else wrong, yet. Just bought it today and installed it and it looks fabulous. Really changes the whole kitchen (that and we had a ver ugly old faucet with chipping chrome.)One good point the couple at the store had was that unless you're very clean and wipe down a chrome faucet, the chrome will always be water=spotted and dirty. True, very true, so thats why I went stainless steel, which is surprisingly much more expensive than the chrome.Very happy with the purchase. Didn't give it five stars because of the drip and the price. This is a very expensive faucet for such a simple design, but it fit best in our decor/ kitchen so thats what I went with, very simple and elegant.NOTE: If you are removing an old faucet, get the proper tools. There is a special wrench for taking out the old nut under the sink. That nut will probably be rusted on solid. I put PB blaster (or WD40) and let it sit over night. I also pulled out my trusty pipe to use as an extension for the little handle on the special wrench so I could get some leverage. Finally, I had a propane torch to heat up the nut when the previous trick didn't really work. The nut finally broke free. Its a 14mm or 9/16 deep socket to get the nut off. Once you get that nut off, its cake.Hope this was helpful.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น